Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 861/970
11.2.5.2 Configuring IPv6 Interface Configuration Page
Selection Criteria
Interface - Selects the interface to be configured. When the selection is changed, a
screen refresh will occur causing all fields to be updated for the newly selected port. All
physical interfaces are valid.
IPv6 Address - Specifies IPv6 prefix with prefix length for an interface. When the selection
is changed screen is refreshed and valid lifetime, preferred lifetime, on-link flag and
autonomous flag will be updated for selected IPv6 address.
Configurable Data
IPv6 Mode - When ipv6 mode is enabled, interface is capable of ipv6 operation without a
global address. In this case, an eui-64 based link-local address is used. This selector lists
the two options for ipv6 mode: enable and disable. Default value is disable.
IPv6 Address - Specifies IPv6 prefix with prefix length for an interface.
EUI-64 - Specifies 64 bit unicast prefix.
Valid Lifetime - Specifies router advertisement per prefix time to consider prefix valid for
purposes of on link determination. Valid lifetime must be in the range (0 to 4294967295)
Preferred Lifetime - Specifies router advertisement per prefix time. An autoconfigured
address generated from this prefix is preferred. Preferred lifetime must be in range (0 to
-1)
OnLink Flag - Specifies selected prefix can be used for on-link determination. Default
value is enable. This selector lists the two options for on-link flag: enable and disable.
Autonomous Flag - Specifies selected prefix can be used for autonomous address
configuration. Default value is disable. This selector lists the two options for automonous
flag: enable and disable.
Routing Mode - Specifies routing mode of an interface. This selector lists the two options
for routing mode: enable and disable. Default value is disable.
Administrative Mode - Specifies administrative mode of an interface. This selector lists
the two options for administrative mode: enable and disable. Default value is enable.
IPv6 Routing Operational Mode - Specifies operational state of an interface. Default
value is disable.
To Next Page
Loading...
Need help?
General
