Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 146/970
6.2.9 MLD Snooping Querier
6.2.9.1 Show Commands
6.2.9.1.1. Display MLD snooping querier global information
This command display MLD snooping querier global information on the system.
Syntax
show ipv6 mld snooping querier
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
MLD Snooping Querier Mode: Specify the Snooping Querier Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on the
VLAN on which query is being sent.
Querier Address: Specify the Snooping Querier Address to be used as source address in
periodic MLD queries. This address is used when no address is configured on the VLAN on
which query is being sent.
MLD Version: Specify the MLD protocol version used in periodic MLD queries.
Querier Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default
value is 60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier
information is removed. The Querier Expiry Interval must be a value in the range of 60 and
300. The default value is 60
6.2.9.1.2. Display MLD snooping querier vlan information
This command display MLD snooping querier vlan information on the system.
Syntax
To Next Page
Loading...
Need help?
General
