QUANTA LB4M - Area Virtual-Link Hello-Interval (Ospfv3); Area Virtual-Link Retransmit-Interval (Ospfv3)

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 596/970
40 seconds.
Command Mode
Router OSPFv3 Config
9.4.2.24 area virtual-link hello-interval (OSPFv3)
This command configures the hello interval for the OSPF virtual interface on the interface
identified by <areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> hello-interval <1-65535>
no area <areaid> virtual-link <neighborid> hello-interval
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<1-65535> - The range of the hello interval is 1 to 65535.
<no> - This command configures the default hello interval for the OSPF virtual interface on
the interface identified by <areaid> and <neighborid>.
Default Setting
10 seconds.
Command Mode
Router OSPFv3 Config
9.4.2.25 area virtual-link retransmit-interval (OSPFv3)
This command configures the retransmit interval for the OSPF virtual interface on the interface
identified by <areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> retransmit-interval <0-3600>
no area <areaid> virtual-link <neighborid> retransmit-interval
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<0-3600> - The range of the retransmit interval is 0 to 3600.
<no> - This command configures the default retransmit interval for the OSPF virtual