Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 411/970
Syntax
queue trust {dot1p | ip-dscp | untrusted } all
no queue trust all
no - This command sets the class of service trust mode to untrusted for all interfaces.
Default Setting
None
Command Mode
Global Config.
6.21.2.3 queue cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface
queue.
Syntax
queue cos-queue min-bandwidth <bw-0> <bw-1> …
……
… <bw-6>
no queue cos-queue min-bandwidth
<bw-0> <bw-1> …
……
… <bw-6>- Each Valid range is (0 to 100) in increments of 5 and the
total sum is less than or equal to 100.
no - This command restores the default for each queue's minimum bandwidth value.
Default Setting
None
Command Mode
Interface Config.
To Next Page
Loading...
Need help?
General
