Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 600/970
set to 0, the router will not leave Overflow State until restarted.
Syntax
exit-overflow-interval <0-2147483647>
no exit-overflow-interval
<0-2147483674> - The range of exit overflow interval for OSPF is 0 to 2147483674.
<no> - This command configures the default exit overflow interval for OSPF.
Default Setting
0.
Command Mode
Router OSPFv3 Config
9.4.2.32 external-lsdb-limit (OSPFv3)
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no
limit. When the number of non-default AS-external-LSAs in a router's link-state database
reaches the external LSDB limit, the router enters overflow state. The router never holds more
than the external LSDB limit non-default AS-external-LSAs in it database. The external LSDB
limit MUST be set identically in all routers attached to the OSPF backbone and/or any regular
OSPF area.
Syntax
external-lsdb-limit <-1-2147483647>
no external-lsdb-limit
<-1-2147483647> - The range of external LSDB limit for OSPF is -1 to 2147483674.
<no> - This command configures the default external LSDB limit for OSPF.
Default Setting
-1.
Command Mode
Router OSPFv3 Config
To Next Page
Loading...
Need help?
General
