Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 706/970
11.2.2.3.5. Resetting VLAN Configuration Page
Command Buttons
Reset - If you select this button and confirm your selection on the next screen, all VLAN
configuration parameters will be reset to their factory default values. Also, all VLANs,
except for the default VLAN, will be deleted. The factory default values are:
All ports are assigned to the default VLAN of 1.
All ports are configured with a PVID of 1.
All ports are configured to an Acceptable Frame Types value of Admit All Frames.
All ports are configured with Ingress Filtering disabled.
All ports are configured to transmit only untagged frames.
GVRP is disabled on all ports and all dynamic entries are cleared.
GVRP is disabled for the switch and all dynamic entries are cleared.
GMRP is disabled on all ports and all dynamic entries are cleared.
GMRP is disabled for the switch and all dynamic entries are cleared.
To Next Page
Loading...
Need help?
General
