QUANTA LB4M - Dot1 X Configuration Commands; Dot1 X Initialize; Username Login

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 270/970
Global Config
6.8.2.3 username login
This command assigns the specified authentication login list to the specified user for system
login. The <username> must be a configured <username> and the <listname> must be a
configured login list.
If the user is assigned a login list that requires remote authentication, all access to the interface
from all CLI, web, and telnet sessions will be blocked until the authentication is complete.
Note that the login list associated with the ‘admin’ user cannot be changed to prevent
accidental lockout from the switch.
Syntax
username login <user> <listname>
<user> - is the login user name.
<listname> - an authentication login list.
Default Setting
None
Command Mode
Global Config
6.8.3 Dot1x Configuration Commands
6.8.3.1 dot1x initialize
This command begins the initialization sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Syntax