QUANTA LB4M - Configuration Commands; Interface Tunnel; Tunnel Source

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 552/970
9.1.2 Configuration Commands
9.1.2.1 interface tunnel
This command uses to enter the Interface Config mode for a tunnel interface. The <tunnel-id>
range is 0 to 7.
Syntax
interface tunnel <0-7>
no interface tunnel <0-7>
no - This command removes the tunnel interface and associated configuration
parameters for the specified tunnel interface.
Default Setting
None
Command Mode
Global Config
9.1.2.2 tunnel source
This command specifies the source transport address of the tunnel, either explicitly or by
reference to an interface.
Syntax
tunnel source {<ipv4-address> | <ethernet> <slot/port>}
<slot/port> - The Interface number.
<ipv4-address> - A valid IP Address.
Default Setting
None
Command Mode
Interfacel Config