QUANTA LB4M - Ip Route Default-Next-Hop; Ip Route Precedence

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 432/970
Global Config
7.2.2.5 ip route default-next-hop
This command configures the default route.
Syntax
ip route default-next-hop <nexthopip> [1-255]
<nexthopip> - IP address of the next hop router.
<1-255> - Precedence value of this route.
Default Setting
None
Command Mode
Global Config
7.2.2.6 ip route precedence
This command sets the default precedence for static routes. Lower route preference values are
preferred when determining the best route. The "ip route" and "ip default-next-hop" commands
allow you to optionally set the precedence of an individual static route. The default precedence
is used when no precedence is specified in these commands. Changing the default
precedence does not update the precedence of existing static routes, even if they were
assigned the original default precedence. The new default precedence will only be applied to
static routes created after invoking the "ip route precedence" command.
Syntax
ip route precedence <1-255>
<1-255> - Default precedence value of static routes. The range is 1 to 255.
Default Setting
The default precedence value is 1.
Command Mode
Global Config