Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 201/970
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (See ‘snmpserver
enable traps linkmode’ command.)
Syntax
snmptrap link-status all
no snmptrap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see
“snmpserver enable traps linkmode”).
Default Setting
Disabled
Command Mode
Global Config
6.3.5.4 snmptrap <name> <ipaddr> <snmpversion>
This command adds an SNMP trap name. The maximum length of the name is 16
case-sensitive alphanumeric characters.
Syntax
snmptrap <name> <ipaddr> <snmpversion>
no snmptrap <name> <ipaddr> <snmpversion>
<name> - SNMP trap name (Range: up to 16 case-sensitive alphanumeric characters).
<ipaddr> - an IP address of the trap receiver.
<snmpversion> - SNMP trap version.
no - This command deletes trap receivers for a community.
To Next Page
Loading...
Need help?
General
