Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 493/970
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
MAC Address used by Routing VLANs Is the MAC Address associated with the internal
bridgerouter interface (IBRI). The same MAC Address is used by all VLAN routing interfaces.
It will be displayed above the per-VLAN information.
VLAN ID Is the identifier of the VLAN.
Logical Interface Indicates the logical slot/port associated with the VLAN routing interface.
IP Address Displays the IP Address associated with this VLAN.
Subnet Mask Indicates the subnet mask that is associated with this VLAN.
.
7.8.2 vlan routing
This command creates routing on a VLAN.
Syntax
vlan routing <vlanid>
no vlan routing <vlanid>
<vlanid> - The range is 1 to 3965.
no - Delete routing on a VLAN.
Default Setting
None
Command Mode
VLAN Database
7.9 Virtual Router Redundancy Protocol (VRRP) Commands
7.9.1 Show Commands
7.9.1.1 show ip vrrp
This command displays whether VRRP functionality is enabled or disabled. It also displays
To Next Page
Loading...
Need help?
General
