QUANTA LB4M - Bootpdhcprelay Serverip; Sflow Commands; Show Sflow Information

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 216/970
Default Setting
4
Command Mode
Global Config
6.3.9.3 bootpdhcprelay serverip
This command is used to configure the server IP Address for BootP/DHCP Relay on the
system.
Syntax
bootpdhcprelay serverip <ipaddr>
no bootpdhcprelay serverip
<ipaddr> - A server IP address.
no - This command is used to reset to the default value.
Default Setting
IP 0.0.0.0
Command Mode
Global Config
6.3.10 sFlow Commands
6.3.10.1 show sFlow information
The user can go to the CLI Privilege Mode to get all of sFlow information, use the show
sflow Privilege command.
Syntax
show sflow