Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 452/970
area <areaid> nssa no- summary
<areaid> - Area ID.
Default Setting
None
Command Mode
Router OSPF Config
7.3.2.10 area nssa translator-role
This command configures the translator role of the NSSA.
Syntax
area <areaid> nssa translator-role {always | candidate}
no area <areaid> nssa translator-role
<areaid> - Area ID.
always - A value of always will cause the router to assume the role of the translator when it
becomes a border router.
candidate - a value of candidate will cause the router to participate in the translator
election process when it attains border router status.
no - Disables the nssa translator role from the specified area id.
Default Setting
None
Command Mode
Router OSPF Config
7.3.2.11 area nssa translator-stab-intv
This command configures the translator stability interval of the NSSA. The <stabilityinterval> is
the period of time that an elected translator continues to perform its duties after it determines
that its translator status has been deposed by another router.
To Next Page
Loading...
Need help?
General
