Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 584/970
Privileged Exec, User Exec
Display Messages
Area Id Is the area id of the requested OSPFv3 area.
Neighbor Is the neighbor interface of the OSPFv3 virtual interface.
Hello Interval Is the configured hello interval for the OSPFv3 virtual interface.
Dead Interval Is the configured dead interval for the OSPFv3 virtual interface.
Retransmit Interval Is the configured retransmit interval for the OSPFv3 virtual interface.
Transit Delay Is the configured transit delay for the OSPFv3 virtual interface.
9.4.2 Configuration Commands
9.4.2.1 Ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
Syntax
Ipv6 ospf
no ipv6 ospf
<no> - This command disables OSPF on a router interface or loopback interface.
Default Setting
Disabled
Command Mode
Interface Config
9.4.2.2 ipv6 ospf areaid
This command sets the OSPF area to which the specified router interface belongs. The
<areaid> is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value
in the range of <0-42949
67295>. The <areaid>
uniquely identifies the
area to whi
ch the
interface connects. Assigning an area id, which does not exist on an interface, causes the area
to be created with default values.
Syntax
To Next Page
Loading...
Need help?
General
