Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 181/970
Default Setting
None
Command Mode
Privileged Exec
6.3.3.2 show line vty
This command displays telnet settings.
Syntax
show line vty
Default Setting
None
Command Mode
Privileged Exec
Display Message
Remote Connection Login Timeout (minutes): This object indicates the number of
minutes a remote connection session is allowed to remain inactive before being logged off. A
zero means there will be no timeout. May be specified as a number from 0 to 160. The
factory default is 5.
Maximum Number of Remote Connection Sessions: This object indicates the number of
simultaneous remote connection sessions allowed. The factory default is 5.
Allow New Telnet Sessions: Indicates that new telnet sessions will not be allowed when
set to no. The factory default value is yes.
Password Threshold: When the logon attempt threshold is reached on the console port, the
system interface becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the silent time command to set this interval.) When this threshold is
reached for Telnet, the Telnet logon interface closes.
Telnet Server Admin Mode: The telnet server admin mode status. The factory default is
enable
Terminal Length: The columns per page for terminal vty port.
6.3.3.3 line vty
This command is used to enter vty (Telnet) configuration mode.
To Next Page
Loading...
Need help?
General
