QUANTA LB4M - Tacacs Timeout

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 287/970
Default Setting
None
Command Mode
Tacacs Host Config
This command is used to configure the TACACS+ authentication host port.
Syntax
port <port-number>
< port-number> - The valid port number. Range (0 – 65535)>
Default Setting
49
Command Mode
Tacacs Host Config
This command is used to configure the TACACS+ authentication host priority.
Syntax
priority <priority>
< priority > - The valid priority number. Range (0 – 65535)>
Default Setting
0
Command Mode
Tacacs Host Config
6.8.5.3 tacacs timeout
This command is used to configure the TACACS+ connection timeout value.