Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 324/970
None
Command Mode
Global Config
6.12.2.13 lldp med faststartrepeatcount
The user can go to the CLI Global Configuration Mode to set
the fast start repeat count, use the
lldp med faststartrepeatcount Global configuration command. Use the no lldp med
faststartrepeatcount to return the default value 3.
Syntax
lldp med faststartrepeatcount
no lldp med faststartrepeatcount
Default Setting
3
Command Mode
Global Config
6.12.2.14 lldp med transmit-tlv all
The user can go to the CLI Global Configuration Mode to set Type Length Values (TLVs) in the
LLDP-MED, use the lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse]
[inventory][location] [network-policy]Global configuration command. Use the no lldp med
transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy] to
remove Type Length Values (TLVs) in the LLDP-MED
Syntax
lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy]
no lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy]
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
To Next Page
Loading...
Need help?
General
