QUANTA LB4M - Snmp-Server Enable Traps

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 194/970
ANDed with the mask to determine the range of allowed client IP addresses. The name is the
applicable community name.
Syntax
snmp-server host <ipaddr> <name>
no snmp-server host <name>
<name> - community name.
<ipaddr> - a client IP address.
no - This command sets a client IP address for an SNMP community to 0.0.0.0. The name
is the applicable community name.
Default Setting
0.0.0.0
Command Mode
Global Config
6.3.4.8 snmp-server enable traps
This command enables the acl trap.
Syntax
snmp-server enable traps acl-trapflags
no snmp-server enable traps acl-trapflags
no - This command disables the acl trap.
Default Setting
Enabled
Command Mode
Global Config