QUANTA LB4M User Manual

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 435/970
7.3.1.1 show ip ospf
This command displays information relevant to the OSPF router
Syntax
show ip ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
Router ID Is a 32 bit integer in dotted decimal format identifying the router.
OSPF Admin Mode The administrative mode of OSPF in the router.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable implies that
the router is an autonomous system border router. Router automatically becomes an ASBR
when it is configured to redistribute routes learned from other protocol. The possible
values for the ASBR status is enabled (if the router is configured to re-distribute routes learnt
by other protocols) or disabled (if the router is not configured for the same).
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled. This is
a configured value.
ABR Status Reflects the whether or not the router is an OSPF Area Border Router.
Exit Overflow Interval The number of seconds that, after entering OverflowState, a router
will attempt to leave OverflowState.
External LSA count The number of external (LS type 5) link-state advertisements in the
link-state database.
External LSA Checksum A number which represents the sum of the LS checksums of
external link-state advertisements contained in the link-state database.
New LSAs Originated The number of new link-state advertisements that have been
originated.
LSAs Received The number of link-state advertisements received determined to be new
instantiations.
External LSDB Limit The maximum number of non-default AS-external-LSAs entries that
can be stored in the link-state database.
Default-metric RDefault value for redistributed routes.
Default Route Advertise Enable or Disable Default Route Advertise.
Always Sets the router advertise 0.0.0.0/0.0.0.0 when set to "True".
Metric Specifies the metric of the default route. The valid values are (0 to 16777215).
Metric Type Metric type of the default route. The valid values are External Type 1 and
External Type 2.
Maximum Paths Maximum number of paths that OSPF can report for a given destination.

QUANTA LB4M Specifications

General

Brand	QUANTA
Model	LB4M
Category	Switch
Language	English