Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 234/970
Syntax
spanning-tree hello-time <1-10>
no spanning-tree hello-time
<1-10> - hellotime value (Range: 1 – 10).
no - This command sets the Hello Time parameter for the common and internal spanning
tree to the default value, that is, 2.
Default Setting
2
Command Mode
Global Config
6.4.2.7 spanning-tree max-age
This command sets the Bridge Max Age parameter to a new value for the common and internal
spanning tree. The max-age value is in seconds within a range of 6 to 40, with the value being
less than or equal to "2 times (Bridge Forward Delay - 1)" and greater than or equal to “2 times
(Bridge Hello Time + 1)”.
Syntax
spanning-tree max-age <6-40>
no spanning-tree max-age
<6-40> - the Bridge Max Age value (Range: 6 – 40).
no - This command sets the Bridge Max Age parameter for the common and internal
spanning tree to the default value, that is, 20.
Default Setting
20
Command Mode
Global Config
To Next Page
Loading...
Need help?
General
