Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 409/970
Syntax
show queue cos-queue <slot/port>
< slot/port > The interface number.
Default Setting
None
Command Mode
Privileged EXEC
Display Message
Interface This displays the slot/port of the interface. If displaying the global configuration,
this output line is replaced with a Global Config indication.
Interface Shaping Rate The maximum transmission bandwidth limit for the interface as a
whole. It is independent of any per-queue maximum bandwidth value(s) in effect for the
interface. This is a configured value.
The following information is repeated for each queue on the interface.
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is
platform dependent.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the queue,
expressed as a percentage. A value of 0 means bandwidth is not guaranteed and the
queue operates using best-effort. This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict
priority or a weighted scheme. This is a configured value.
Queue Mgmt Type The queue depth management technique used for this queue, either
tail drop or weighted random early discard (WRED). This is a configured value.
6.21.2 Configuration Commands
6.21.2.1 queue cos-map
This command maps an 802.1p priority to an internal traffic class on a "per-port" basis.
Syntax
To Next Page
Loading...