Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 321/970
6.12.2.7 lldp timers
This command is used to set the timing parameters for local data transmission on ports
enabled for LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier range
is 2-10. The <reinit-seconds> is the delay before re-initialization, and the range is 1-0 seconds.
Syntax
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-seconds>]
no lldp timers [interval] [hold] [reinit]
<interval-seconds> - Configures the number of seconds to wait between transmitting
local data LLDPDUs
<hold-value> - Configures the multiplier on the transmit interval that sets the TTL in local
data LLDPDUs
<reinit-seconds> - Configures the delay before re-initialization
no - This command is used to return any or all timing parameters for local data
transmission on ports enabled for LLDP to the default values.
Default Setting
Interval-seconds 30
Hold-value 4
Reinit-seconds 2
Command Mode
Global Config
6.12.2.8 lldp med
The user can go to the CLI Interface Configuration Mode to set MED to enable, use the lldp
med Interface configuration command. Use the no lldp med to disable med function.
Syntax
To Next Page
Loading...
Need help?
General
