Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 583/970
9.4.1.13 show ipv6 ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and
neighbor.
Syntax
show ip osp
fv6 v
irtual-link <areaid>
<neighbor>
<areaid> - Area ID.
<neighbor> - Neighbor's router ID.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
Area ID The area id of the requested OSPF area.
Neighbor Router ID The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPF virtual interface.
Retransmit Interval The configured retransmit interval for the OSPF virtual interface.
Authentication Type Shows the type of authentication the interface performs on LSAs it
receives.
State The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router. This is the state of the OSPF interface.
Neighbor State The neighbor state.
9.4.1.14 show ipv6 ospf virtual-link brief
This command displays the OSPFv4 Virtual Interface information for all areas in the system.
Syntax
To Next Page
Loading...
Need help?
General
