Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 476/970
domain name list, the default domain name is not used.
Default Setting
None
Command Mode
Global Mode
7.5.2.5 ip name-server
This command specifies the address of one or more domain name servers to use for
name-to-address resolution. There are maximum 6 entries in the Domain Name Server Table.
Syntax
ip name-server <ipaddr>
no ip name-server <ipaddr>
< ipaddr > - IP address of the Domain Name Servers.
<no> - Remove the corresponding Domain Name Server entry from the table.
Note - The listed name servers are queried in the specified sequence until a response is
received, or the end of the list is reached with no response.
Default Setting
None
Command Mode
Global Mode
7.5.2.6 ip domain-lookup
This command enables the IP Domain Naming System (DNS)-based host name-to-address
translation.
Syntax
To Next Page
Loading...
Need help?
General
