Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 425/970
Next Hop IP Address: The outgoing router IP address to use when forwarding traffic to the
next router (if any) in the path toward the destination.
7.2.1.6 show ip route entry
This command displays the router route entry information.
Syntax
show ip route entry <networkaddress>
<networkaddress> - Is a valid network address identifying the network on the
specified interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Network Address: Is a valid network address identifying the network on the specified
interface.
Subnet Mask: Is a mask of the network and host portion of the IP address for the attached
network.
Protocol: Tells which protocol added the specified route. The possibilities are: local, static,
OSPF, or RIP.
Total Number of Routes: The total number of routes.
for each next hop
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next
destination.
Next Hop IP Address: The outgoing router IP address to use when forwarding traffic to the
next router (if any) in the path toward the destination.
Preference: The preference value that is used for this route entry.
Metric: Specifies the metric for this route entry.
7.2.1.7 show ip route connected
This command displays directly connected routes.
To Next Page
Loading...
Need help?
General
