Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 573/970
Router ID Is a 32 bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is
enabled or disabled. This is a configured value.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable implies that
the router is an autonomous system border router. Router automatically becomes an ASBR
when it is configured to redistribute routes learnt from other protocol. The possible values for
the ASBR status is enabled (if the router is configured to re-distribute routes learnt by other
protocols) or disabled (if the router is not configured for the same).
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval Shows the number of seconds that, after entering Overflow State, a
router will attempt to leave Overflow State.
External LSA Count Shows the number of external (LS type 5) link-state advertisements in
the link-state database.
External LSA Checksum Shows the sum of the LS checksums of external link-state
advertisements contained in the link-state database.
New LSAs Originated Shows the number of new link-state advertisements that have been
originated.
LSAs Received Shows the number of link-state advertisements received determined to be
new instantiations.
External LSDB Limit Shows the maximum number of non-default AS-external-LSAs entries
that can be stored in the link-state database.
Default Metric Default value for redistributed routes.
Default Route Advertise Indicates whether the default routes received from other source
protocols are advertised or not
Always Shows whether default routes are always advertised.
Metric Shows the metric for the advertised default routes. If the metric is not configured, this
field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths Shows the maximum number of paths that OSPF can report for a given
destination.
Redistributing This field is a heading and appears only if you configure the system to take
routes learned from a non-OSPF source and advertise them to its peers.
Source Shows source protocol/routes that are being redistributed. Possible values are static,
connected, or RIP.
Metric Shows the metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the specified
protocol.
Distribute-List Shows the access list used to filter redistributed routes.
9.4.1.2 show ip ospf abr
This command displays the internal OSPFv3 routes to reach Area Border Routers (ABR).This
command takes no options.
Syntax
To Next Page
Loading...
Need help?
General
