Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 523/970
[ipaddr]" command. The results subsequent to the completion of the latest "mrinfo" will be
available in the buffer pool after a maximum duration of two minutes after the completion of the
‘show mrinfo’ command. A subsequent issue ‘mrinfo’ will overwrite the contents of the buffer
pool with fresh results.
Syntax
show mrinfo
Default Setting
None
Command Mode
Privileged Exec
Display Message
Router Interface: The IP address of this neighbor.
Neighbor: The neighbor associated with the router interface.
Metric: The metric value associated with this neighbor.
TTL: The TTL threshold associated with this neighbor.
Flags: Status of the neighbor.
8.3.1.6 show mstat
This command is used to display the results of packet rate and loss information from the results
buffer pool of the router, subsequent to the execution/completion of a ‘mstat <source> [group]
[receiver]’ command. Within two minutes of the completion of the ‘mstat’ command, the results
will be available in the buffer pool. The next issuing of "mstat" would overwrite the buffer pool
with fresh results.
Syntax
To Next Page
Loading...
Need help?
General
