Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 107/970
Syntax
switchport {dvlan-tunnel | dot1q-tunnel } ethertype {802.1Q|custom <0-65535>|vman}
Default Setting
Vman
Command Mode
Global Config
6.2.4.3 switchport dvlan-tunnel/ dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
Syntax
switchport {dvlan-tunnel|dot1q-tunnel}
no switchport {dvlan-tunnel|dot1q-tunnel}
Default Setting
Disable
Command Mode
Interface Config
This command enables enable Double VLAN Tunneling for all ports.
Syntax
switchport {dvlan-tunnel|dot1q-tunnel} all
no switchport {dvlan-tunnel|dot1q-tunnel} all
all - All interfaces.
no - This command disables enable Double VLAN Tunneling for all ports.
Default Setting
Disabled
Command Mode
To Next Page
Loading...
Need help?
General
