QUANTA LB4M - Set Encrypted the Password; Unlock a Locked User Acount

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 252/970
operator’s former password. If none, press enter.
Syntax
username <username> {password | nopassword}
no username <username>
<username> - is a new user name (Range: up to 8 characters).
no - This command removes a user name created before.
Note: The admin user account cannot be deleted.
nopassword - This command sets the password of an existing operator to blank. When a
password is changed, a prompt will ask for the operator's former password. If none, press
enter.
Default Setting
No password
Command Mode
Global Config
6.7.2.2 Unlock a locked user acount
The user can go to the CLI Global Configuration Mode to unlock a locked user account, use the
username <name> unlock global configuration command.
Syntax
username <username> unlock
<name> - is a user name (Range: up to 8 characters).
Default Setting
None
Command Mode
Global Config
6.7.2.3 Set encrypted the password