QUANTA LB4M - Show Lldp Med; Show Lldp Med Interface

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 313/970
Management Address: Lists the type of address and the specific address the local LLDP
agent uses to send and receive information.
6.12.1.8 show lldp med
The user can go to the CLI Privilege Mode to display a summary of the current LLDP-MED
configuration, use the show lldp med Privilege command.
Syntax
show lldp med
Default Setting
None
Command Mode
Privileged Exec
Display Message
Fast Start Repeat Count: Specifies the number of LLDP PDUs that will be transmitted when
the protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 3.
Device Class: Specifies local device's MED Classification. There are four different kinds of
devices, three of them represent the actual end points (classified as Class I Generic [IP
Communication Controller etc.], Class II Media [Conference Bridge etc.], Class III
Communication [IP Telephone etc.]). The fourth device is Network Connectivity Device,
which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access
Point etc.
6.12.1.9 show lldp med interface
The user can go to the CLI Privilege Mode to d display a summary of the current LLDP-MED
configuration for a specific interface, use the show lldp med interface {all | <unit/slot/port>}
Privilege command.
Syntax
show lldp med interface {all | <slot/port>}
Default Setting
None
Command Mode
Privileged Exec