Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 567/970
Syntax
ipv6 mtu <1280-1500>
no ipv6 mtu
no – This command resets maximum transmission unit value to default value.
Default Setting
0 or link speed (MTU value is 1500)
Command Mode
Interface Config
9.3.2.7 ipv6 nd dad attempts
This command sets the number of duplicate address detection probes transmitted. Duplicate
address detection verifies that an IPv6 address on an interface is unique.
Syntax
ipv6 nd dad attempts <0 – 600>
no ipv6 nd dad attempts
no – This command resets to number of duplicate address detection value to default
value.
Default Setting
1
Command Mode
Interface Config
9.3.2.8 ipv6 nd managed-config-flag
This command sets the “managed address configuration” flag in router advertisements. When
the value is true, end nodes use DHCPv6. When the value is false, end nodes automatically
configure addresses.
To Next Page
Loading...
Need help?
General
