Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 572/970
9.3.2.16 ipv6 neighbor static
The user can add/delete a static neighbor into neighbor cache table.
Syntax
ipv6 neighbor static <ipv6-address> <mac-address>
no ipv6 neighbor static <ipv6-address>
no – This command sets IPv6 neighbor configuration to default values.
Default Setting
None
Command Mode
Global Config
9.4 OSPFv3 Commands
This section describes the commands you use to configure OSPFv3, which is a link-state
routing protocol that you use to route traffic within a network.
9.4.1 Show Commands
9.4.1.1 show ipv6 ospf
This command displays information relevant to the OSPF router
Syntax
show ipv6 ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
NOTE:
Some of the information below displays only if you enable OSPF and configure
certain features.
To Next Page
Loading...
Need help?
General
