Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 522/970
Flags: This field displays the flags associated with this entry.
If the summary parameter is specified the follow fields are displayed:
Source IP: This field displays the IP address of the multicast data source.
Group IP: This field displays the IP address of the destination of the multicast packet.
Protocol: This field displays the multicast routing protocol by which this entry was created.
Incoming Interface: This field displays the interface on which the packet for this source
arrives.
Outgoing Interface List: This field displays the list of outgoing interfaces on which this
packet is forwarded.
This command displays all the static routes configured in the static mcast table if is specified or
displays the static route associated with the particular <sourceipaddr>.
Syntax
show ip mcast mroute static [<sourceipaddr>]
< sourceipaddr > - the IP Address of the multicast data source.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Source IP: This field displays the IP address of the multicast packet source.
Source Mask: This field displays the mask applied to the IP address of the multicast packet
source.
RPF Address: This field displays the IP address to be used as RPF for the given source and
mask.
Metric: This field displays the metric value corresponding to the source address.
Interface: Valid slot and port number separated by forward slashes.
8.3.1.5 show mrinfo
This command is used to display the neighbor information of a multicast-capable router from
the results buffer pool of the router subsequent to the execution/completion of a "mrinfo
To Next Page
Loading...
Need help?
General
