Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 285/970
6.8.4.9 radius-server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS
client. The primary server is the one that is used by default for handling RADIUS requests. The
remaining configured servers are only used if the primary server cannot be reached. A
maximum of three servers can be configured on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to this command being
executed, the server specified by the IP address specified used in this command will become
the new primary server. The IP address must match that of a previously configured RADIUS
authentication server.
Syntax
radius-server primary <ipaddr>
<ipaddr> - is a IP address.
Default Setting
None
Command Mode
Global Config
6.8.5 TACACS+ Configuration Commands
6.8.5.1 tacacs host
This command is used to enable /disable TACACS+ function and to configure the TACACS+
server IP address. The system has not any TACACS+ server configured for its initialization and
support 5 TACACS+ servers.
Syntax
To Next Page
Loading...
Need help?
General
