Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 575/970
are enabled and disabled. This is a configured value.
Import Summary LSAs Shows whether to import summary LSAs (enabled).
OSPF Stub Metric Value Shows the metric value of the stub area. This field displays only if
the area is a configured as a stub area.
The following OSPF NSSA specific information displays only if the area is configured
as an NSSA.
Import Summary LSAs Shows whether to import summary LSAs into the NSSA.
Redistribute into NSSA Shows whether to redistribute information into the NSSA.
Default Information Originate Shows whether to advertise a default route into the NSSA
Default Metric Shows the metric value for the default route advertised into the NSSA.
Default Metric Type Shows the metric type for the default route advertised into the NSSA.
Translator Role Shows the NSSA translator role of the ABR, which is always or candidate.
Translator Stability Interval Shows the amount of time that an elected translator continues
to perform its duties after it determines that its translator status has been deposed by
another router.
Translator State Shows whether the ABR translator state is disabled, always, or elected.
9.4.1.4 show ipv6 ospf asbr
This command displays the internal OSPFv3 routes to reach Autonomous System Boundary
Routers (ASBR). This command takes no options.
Syntax
show ipv6 ospf asbr
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
Type: The type of the route to the destination. It can be either:
intra — Intra-area route
inter — Inter-area route
Router ID: Router ID of the destination
Cost: Cost of using this route
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
9.4.1.5 show ipv6 ospf database
To Next Page
Loading...