Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 901/970
Non-Configurable Data
IPv6 Prefix/Prefix Length - Displays the Network Prefix and Prefix Length for the
Configured Route.
Next Hop IP - Displays the Next Hop IPv6 Address for the Configured Route.
Preference - Displays the Route Preference of the Configured Route.
Command Buttons
Add IPv6 Route - Allows the user to configure a new route.
Delete - Deletes the corresponding route.
11.2.5.10 Managing RIPv6
11.2.5.10.1. Configuring RIPv6 Configuration Page
Configurable Data
RIPv6 Admin Mode - Select enable or disable from the pulldown menu. If you select
enable RIPv6 will be enabled for the switch. The default is disable.
Split Horizon Mode - Select none, simple or poison reverse from the pulldown menu. Split
horizon is a technique for avoiding problems caused by including routes in updates sent to
the router from which the route was originally learned. The options are:
None - no special processing for this case.
Simple - a route will not be included in updates sent to the router from which it was
learned.
Poisoned reverse
-
a route will be included in updates sent to the router from which
it was learned, but the metric will be set to infinity.
The default is simple.
Update Time - Configure the Ripng update time.
To Next Page
Loading...