Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 457/970
7.3.2.18 area virtual-link retransmit-interval
This command configures the retransmit interval for the OSPF virtual interface on the interface
identified by <areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> retransmit-interval <0-3600>
no area <areaid> virtual-link <neighborid> retransmit-interval
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<0-3600> - The range of the retransmit interval is 0 to 3600.
<no> - This command configures the default retransmit interval for the OSPF virtual
interface on the interface
identified by <areai
d>
and <neighborid>.
Default Setting
The default value of retransmit interval is 5 seconds.
Command Mode
Router OSPF Config
7.3.2.19 area virtual-link transmit-delay
This command configures the transmit delay for the OSPF virtual interface on the virtual
interface identified by
<areaid>
and <nei
ghborid>.
Syntax
area <areaid> virtual-link <neighborid> transmit-delay <0-3600>
no area <areaid> virtual-link <neighborid> transmit-delay
<areaid> - Area ID.
<neighbor> - Router ID of the neighbor.
<0-3600> - The range of the transmit delay is 0 to 3600.
<no> - This command configures the default transmit delay for the OSPF virtual interface
on the virtual interface
identified by <areaid>
and
<neighborid>.
To Next Page
Loading...
Need help?
General
