Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 598/970
metric - The range of the metric is 1 to 16777215.
metric type - The value of metric type is type 1 or type 2.
<no> - This command configures the default advertisement of default routes.
Default Setting
Metric: unspecified
Type: 2
Command Mode
Router OSPFv3 Config
9.4.2.28 default-metric (OSPFv3)
This command is used to set a default for the metric of distributed routes.
Syntax
default-metric <1-16777215>
no default-metric
<1-16777215> - The range of default metric is 1 to 16777215.
<no> - This command is used to set a default for the metric of distributed routes.
Default Setting
None
Command Mode
Router OSPFv3 Config
9.4.2.29 distance ospf (OSPFv3)
This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF can be intra, inter,
type-1, or type-2. The OSPF specification (RFC 2328) requires that preferences must be given
to the routes learned via OSPF in the following order: intra < inter < type-1 < type-2. The
<preference> range is 1 to 255. A route with a preference of 255 cannot be used to forward
traffic.
Syntax
To Next Page
Loading...
Need help?
General
