Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 320/970
This command uses to include transmission of the local system management address
information in the LLDPDUs.
Syntax
lldp transmit-mgmt
no lldp transmit-mgmt
no - This command is used to cancel inclusion of the management information in
LLDPDUs.
Default Setting
None
Command Mode
Interface Config
6.12.2.6 lldp transmit-tlv
This command is used to specify which optional type length values (TLVs) in the 802.1AB
basic management set are transmitted in the LLDPDUs. Use sys-name to transmit the system
name TLV. To configure the system name, please refer to “snmp-server” command. Use
sys-descto transmit the system description TLV. Use sys-cap to transmit the system
capabilities TLV. Use port-desc to transmit the port description TLV. To configure the port
description, please refer to “description” command.
Syntax
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
no - This command is used to remove an optional TLV from the LLDPDUs. Use the
command without parameters to remove all optional TLVs from the LLDPDU.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General
