QUANTA LB4M - Configuration Commands; Enable Ospf; No Area

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 448/970
7.3.2 Configuration Commands
7.3.2.1 enable ospf
This command resets the default administrative mode of OSPF in the router to active.
Syntax
enable
no enable
<no> - This command sets the administrative mode of OSPF in the router to inactive.
Default Setting
Enabled
Command Mode
Router OSPF Config
7.3.2.2 no area
This command removes an OSPF area.
Syntax
no area <areaid>
Default Setting
None
Command Mode
Router OSPF Config