Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 542/970
8.5.2.4 ip pimsm spt-threshold
This command is used to configure the Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobytes per second. The possible values are 0 to 2000.
Syntax
ip pimsm spt-threshold <0 - 2000>
no ip pimsm spt-threshold
<0 - 2000> - This is time interval in seconds.
no - This command is used to reset the Threshold rate for the last-hop router to switch to
the shortest path to the default value.
Default Setting
50
Command Mode
Global Config
8.5.2.5 ip pimsm staticrp
This command is used to create RP IP address for the PIM-SM router. The parameter
<rp-address> is the IP address of the RP. The parameter <group-address> is the group
address supported by the RP. The parameter <group-mask> is the group mask for the group
address.
Syntax
ip pimsm staticrp <rp-address> <group-address> <group-mask>
no ip pimsm staticrp <rp-address> <group-address> <group-mask>
< rp-address > - the IP Address of the RP.
< group-address > - the group address supported by the RP.
< group-mask > - the group mask for the group address.
no - This command is used to delete RP IP address for the PIM-SM router. The parameter
<rp-address> is the IP address of the RP. The parameter <group-address> is the group
address supported by the RP. The parameter <group-mask> is the group mask for the
group address.
To Next Page
Loading...
Need help?
General
