Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 282/970
65535, with 1812 being the default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS
accounting server. Only a single accounting server can be configured. If an accounting server
is currently configured, it must be removed from the configuration using the no form of the
command before this command succeeds. If the optional <port> parameter is used, the
command will configure the UDP port to use to connect to the RADIUS accounting server. The
IP address specified must match that of a previously configured accounting server. If a port is
already configured for the accounting server then the new port will replace the previously
configured value. The port must be a value in the range 1 - 65535, with 1813 being the default
value.
Syntax
radius-server host {acct | auth} <ipaddr> [port]
no radius-server host {acct | auth} <ipaddr>
<ipaddr> - is a IP address.
[port] - Port number (Range: 1 – 65535)
no -
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is
used, the previously configured RADIUS accounting server is removed from the
configuration. The <ipaddr> parameter must match the IP address of the previously
configured RADIUS authentication / accounting server.
Default Setting
None
Command Mode
Global Config
6.8.4.5 radius-sever key
This command is used to configure the shared secret between the RADIUS client and the
RADIUS accounting / authentication server. Depending on whether the 'auth' or 'acct' token is
used, the shared secret will be configured for the RADIUS authentication or RADIUS
accounting server. The IP address provided must match a previously configured server. When
this command is executed, the secret will be prompted. The secret must be an alphanumeric
value not exceeding 20 characters.
To Next Page
Loading...
Need help?
General
