EasyManuals Logo

QUANTA LB4M User Manual

QUANTA LB4M
970 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #221 background imageLoading...
Page #221 background image
UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 221/970
Syntax
show serviceport ndp
Default Setting
None
Command Mode
Privileged Exec
Display Message
IPv6 Address: Specifies the IPv6 address of neighbor or interface.
MAC Address: Specifies MAC address associated with an interface.
isRr:. Specifies router flag.
Neighbor State:
Incmp - Address resolution is being performed on the entry. A neighbor solicitation
message has been sent to the solicited-node multicast address of the target, but the
corresponding neighbor advertisement message has not yet been received.
Reach - Positive confirmation was received within the last Reachable Time milliseconds
that the forward path to the neighbor was functioning properly. While in REACH state,
the device takes no special action as packets are sent.
Stale - More than ReachableTime milliseconds have elapsed since the last positive
confirmation was received that the forward path was functioning properly. While in
STALE state, the device takes no action until a packet is sent.
Delay - More than ReachableTime milliseconds have elapsed since the last positive
confirmation was received that the forward path was functioning properly. A packet was
sent within the last DELAY_FIRST_PROBE_TIME seconds. If no reachability
confirmation is received within DELAY_FIRST_PROBE_TIME seconds of entering the
DELAY state, send a neighbor solicitation message and change the state to PROBE.
Probe - A reachability confirmation is actively sought by resending neighbor solicitation
messages every RetransTimer milliseconds until a reachability confirmation is received.
Last Updated: Time since the address was confirmed to be reachable.
6.3.11.3 serviceport ip
This command sets the IP address, the netmask and the gateway of the network management
port.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QUANTA LB4M and is the answer not in the manual?

QUANTA LB4M Specifications

General IconGeneral
BrandQUANTA
ModelLB4M
CategorySwitch
LanguageEnglish

Related product manuals