Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 271/970
dot1x initialize <slot/port>
<slot/port> - is the desired interface number.
Default Setting
None
Command Mode
Privileged Exec
6.8.3.2 dot1x default-login
This command assigns the authentication login list to use for non-configured users for 802.1x
port security. This setting is over-ridden by the authentication login list assigned to a specific
user if the user is configured locally. If this value is not configured, users will be authenticated
using local authentication only.
Syntax
dot1x default-login <listname>
<listname> - an authentication login list.
Default Setting
None
Command Mode
Global Config
6.8.3.3 dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x
port security. The <user> parameter must be a configured user and the <listname> parameter
must be a configured authentication login list.
To Next Page
Loading...