Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 99/970
Syntax
switchport native vlan <vlanid>
no switchport native vlan <vlanid>
<vlanid> - VLAN ID (Range: 1 –3965).
no - This command sets the VLAN ID per interface to 1.
Default Setting
1
Command Mode
Interface Config
This command changes the VLAN ID for all interfaces.
Syntax
switchport native vlan all <vlanid>
<vlanid> - VLAN ID (Range: 1 –3965).
all - All interfaces.
no - This command sets the VLAN ID for all interfaces to 1.
Default Setting
1
Command Mode
Global Config
6.2.3.17 switchport allowed vlan
This command configures the degree of participation for a specific interface in a VLAN. The ID
is a valid VLAN identification number, and the interface is a valid interface number.
To Next Page
Loading...
Need help?
General
