Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 559/970
OSPF Ext T1 Preference of OSPF Type-1 external routes.
OSPF Ext T2 Preference of OSPF Type-2 external routes.
OSPF NSSA T1 Preference of OSPF NSSA Type 1 routes.
OSPF NSSA T2 Preference of OSPF NSSA Type 1 routes.
9.3.1.6 show ipv6 route summary
This command displays the summary of the routing table. Use all to display the count summary
for all routes, including best and non-best routes. Use the command without parameters to
display the count summary for only the best routes.
Syntax
show ipv6 route summary [all]
Default Setting
None
Command Mode
Privileged Exec
Display Message
Connected Routes: Total number of connected routes in the routing table
Static Routes: Shows whether the IPv6 unicast routing mode is enabled.
OSPF Routes: Total number of routes installed by OSPFv3 protocol.
Number of Prefixes: Summarizes the number of routes with prefixes of different lengths
Total Routes: Shows the total number of routes in the routing table.
9.3.1.7 show ipv6 vlan
This command displays IPv6 VLAN routing interface addresses.
Syntax
To Next Page
Loading...
Need help?
General
