Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 292/970
None
Command Mode
Interface Config
6.9 CDP (Cisco Discovery Protocol) Commands
6.9.1 Show Commands
6.9.1.1 show cdp
This command displays the CDP configuration information.
Syntax
show cdp
Default Setting
None
Command Mode
Privileged Exec
Display Message
CDP Admin Mode: CDP enable or disable
CDP Holdtime (sec): The length of time a receiving device should hold the L2 Network
Switch CDP information before discarding it
CDP Transmit Interval (sec): A period of the L2 Network Switch to send CDP packet
Ports: Port number vs CDP status
CDP: CDP enable or disable
6.9.1.2 show cdp neighbors
This command displays the CDP neighbor information.
To Next Page
Loading...
Need help?
General
