QUANTA LB4M - Snmp-Server Community

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 191/970
<con> - Range is from 1 to 31 alphanumeric characters.
Default Setting
None
Command Mode
Global Config
6.3.4.6 snmp-server community
This command adds (and names) a new SNMP community. A community name is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privilege level. The length of the name can be up to 16 case-sensitive characters.
Note: Community names in the SNMP community table must be unique. If you make multiple
entries using the same community name, the first entry is kept and processed and all duplicate
entries are ignored.
Syntax
snmp-server community <name>
no snmp-server community <name>
<name> - community name (up to 16 case-sensitive characters).
no - This command removes this community name from the table. The name is the
community name to be deleted.
Default Setting
Two default community names: public and private. You can replace these default community
names with unique identifiers for each community. The default values for the remaining four
community names are blank.
Command Mode
Global Config