Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 263/970
Privileged Exec
Display Message
Current Server IP Address: Indicates the configured server currently in use for
authentication
Number of configured servers: The configured IP address of the authentication server
Number of retransmits: The configured value of the maximum number of times a request
packet is retransmitted
Timeout Duration: The configured timeout value, in seconds, for request re-transmissions
RADIUS Accounting Mode: Disable or Enabled
6.8.1.11 show radius accounting
This command is used to display the configured RADIUS accounting mode, accounting server,
and the statistics for the configured accounting server.
Syntax
show radius accounting [statistics <ipaddr>]
<ipaddr> - is an IP Address.
Default Setting
None
Command Mode
Privileged Exec
Display Message
If the optional token 'statistics <ipaddr>' is not included, then only the accounting mode and
the RADIUS accounting server details are displayed.
RADIUS Accounting Mode: Enabled or disabled
IP Address: The configured IP address of the RADIUS accounting server
Port: The port in use by the RADIUS accounting server
Secret Configured: Yes or No
If the optional token 'statistics <ipaddr>' is included, the statistics for the configured RADIUS
accounting server are displayed. The IP address parameter must match that of a previously
configured RADIUS accounting server. The following information regarding the statistics of
the RADIUS accounting server is displayed.
RADIUS Accounting Server IP Address: IP Address of the configured RADIUS accounting
To Next Page
Loading...
Need help?
General
