QUANTA LB4M - Show Telnet

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 187/970
no - This command sets the remote connection session timeout value, in minutes, to the
default.
Note: Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Global Config
6.3.3.13 show telnet
This command displays the current outbound telnet settings.
Syntax
show telnet
Default Setting
None
Command Mode
User Exec, Privileged Exec
Display Message
Outbound Telnet Login Timeout (in minutes) Indicates the number of minutes an
outbound telnet session is allowed to remain inactive before being logged off. A value of 0,
which is the default, results in no timeout.
Maximum Number of Outbound Telnet Sessions Indicates the number of simultaneous
outbound telnet connections allowed.
Allow New Outbound Telnet Sessions Indicates whether outbound telnet sessions will
be allowed.